| Stay Put Body Clips |
|---|
| Posted on Wed 26 Oct 2005 by nitromonkey (1223 reads) |
|
If you're sick of loosing your body pins all the time, then add the-rc-zone body pin chain. You will need crimpers, wire cutters, Phillips screwdriver, hex wrench, drill, body pins, small chain, Ring terminals, square terminals, screws, nuts, and washers. Crimp the chain to the ring terminal. Crimp the other end of the chain to the square terminal. Put a body pin through the small hole in the square terminal. Drill a hole about 1 & 1/2 inch away from the body post hole in the body. Screw a screw through the ring terminal, then body, then washer, then end it off the a nut. Repeat these steps three more times to do all four body posts. Submitted by: http://the-rc-zone.com |
| Index :: Print :: E-mail |
The comments are owned by the poster. We aren't responsible for their content.
![[SUBSCRIBE]](http://www.nitromonkey.com/xoops/modules/evennews/language/english/subscribe.gif)
![[UNSUBSCRIBE]](http://www.nitromonkey.com/xoops/modules/evennews/language/english/unsubscribe.gif)
